SparkFun Qwiic WiFi Shield - DA16200

Ultra. Low. Power. Arguably the best three words in the IoT world. SparkFun has teamed up with ARM and Dialog to provide you with this Qwiic WiFi Shield based around the DA16200 module. The DA16200 is a fully integrated WiFi module with a 40MHz crystal oscillator, 32.768KHz RTC clock, RF Lumped RF filter, 4MB flash memory, and an on-board chip antenna. With the addition of a Qwiic connector, multiple GPIO options, JTAG connectors for deep dive programming, and you've got everything you need to get your R3 layout device ready to set up your next IoT project.

The SparkFun Qwiic WiFi Shield is ideal for door locks, thermostats, sensors, pet trackers, and other home IoT projects, thanks in part to the multiple sleep modes that allow you to take advantage of current draws as low as 0.2uA-3.5uA.

Additionally, the DA16200 module's certified WiFi alliance for IEEE802.11b/g/n, WiFi Direct, and WPS functionalities means that it has been approved for use by multiple countries and using the WiFi Alliance transfer policy, each WiFi Certification can be transferred without being tested again.

Note: Please be aware that logic voltage for the Qwiic DA16200 WiFi Shield is 3.3V only.


The SparkFun Qwiic Connect System is an ecosystem of I2C sensors, actuators, shields and cables that make prototyping faster and less prone to error. All Qwiic-enabled boards use a common 1mm pitch, 4-pin JST connector. This reduces the amount of required PCB space, and polarized connections mean you can’t hook it up wrong.


  • Arm® Cortex®-M4F core w/ clock frequency of 30~160 MHz
  • WiFi processor
    • IEEE 802.11b/g/n, 1x1, 20MHz channel bandwidth, 2.4GHz
    • IEEE 802.11s Wi-Fi mesh
    • WiFi security: WPA/WPA2-Enterprise/Personal, WPA2 SI, WPA3 SAE, and OWE
  • 32 M-bit / 4 M-byte SPI flash Memory
  • 2 UARTs
  • On-Chip RTC
  • Three ultra-low power sleep modes
  • Sleep current: 3.5uA
  • Operating voltage: 2.1V to 3.6V
  • Qwiic Connector for Arduino

SparkFun Qwiic WiFi Shield - DA16200 Product Help and Resources

Dialog ULP WiFi DA16200 R3 Shield Hookup Guide

October 7, 2021

Add WiFi to your project with this hookup guide for our Dialog's Ultra Low Power DA16200 R3 shield!

Getting Started with the DA16200 FreeRTOS SDK

September 15, 2022

Interested in the DA16200 FreeRTOS SDK? This guide covers setting up the SDK in the Eclipse IDE and how to program our boards with the DA16200 module.

Comments

Looking for answers to technical questions?

We welcome your comments and suggestions below. However, if you are looking for solutions to technical questions please see our Technical Assistance page.

Customer Reviews

No reviews yet.